Need advice threaded in metal 3DP (T47 BB thread)

Already try them in resin 3D printed in 50mm width shell it’s works pretty well, perhaps few turns facing in the end of the thread in the brake side because I make them in 46 diameter thread, luckily you mention to refer PF30 standard. Then 46,5mm should be works isn’t ? or must be in 47mm?

Will be 56% silver brazed with Columbus life/spirit steel tubes, also this be my first time experimenting this. That’s why I make this thread (It is possible to braze stainless 316L with alloy steel?)—finger cross hopefully everything run with small error as possible :sweat_smile:

Any additional advice about this? Thanks a lot Daniel